Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1364 (HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS)REMOVAL AND INSTALLATIONLIFTGATE RELEASE SWITCH - LIFTGATE WINDOWREMOVAL AND INSTALLATION
2007 Ford Fusion SEL, 2.3 Z, Standard
Removal and Installation
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the liftgate trim panel. For additional information, refer to LIFTGATE TRIM PANEL .
- Remove the 4 liftgate trim bezel nuts and remove the bezel from the liftgate.
- To install, tighten to 8 Nm (71 lb-in).
- Disconnect the liftgate window release switch electrical connector.
- Using the appropriate tool, press the tabs and remove the liftgate window release switch.
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.