SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1306 (AUTOMATIC TRANSMISSION - 6F35)IN-VEHICLE REPAIRMAIN CONTROL COVERINSTALLATION
2007 Ford Fusion SEL, 2.3 Z, Standard

Main Control Cover: Installation

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the main control cover sealing surface and inspect for damage.
    Fig 1: Locating Main Control Cover Sealing Surface
    G06376682Courtesy of FORD MOTOR CO.
  2. Apply silicone to the main control sealing surface of the transaxle case.
    Fig 2: Locating Silicone Applying Area On Transaxle Case Main Control Sealing Surface
    G06376683Courtesy of FORD MOTOR CO.
  3. Position the main control cover in place.
    Fig 3: Locating Main Control Cover
    G06376684Courtesy of FORD MOTOR CO.
    4. NOTE: Inspect the main control-to-main control cover grommet to make sure that the seal is on the inside of the main control cover. Transmission fluid leak will occur.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.