Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1284 (WINDOWS AND GLASS - GLASS, FRAMES AND MECHANISMS)REMOVAL AND INSTALLATIONWINDOW CONTROL SWITCHREMOVAL AND INSTALLATION

2007 Ford Fusion SEL, 2.3 Z, Standard

Removal and Installation

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Fusion, Milan

Remove the access cover and the screw.
Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward and then shift the switch assembly rearward to disengage the front locking tab.

Fig 1: Prying Rear Of Switch Bezel Upward
Courtesy of FORD MOTOR CO.

MKZ
Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward to disengage the retaining clip, then shift the switch assembly rearward to disengage the front locking tab.
NOTE: For LH front window control switch assembly only, the rear retaining clip is located off-center towards the outside of the vehicle.

All Vehicles
Disconnect the electrical connector(s).
Remove the window control switch.
To install, reverse the removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.