Lead Terminal Repair: Material

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Material
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS TABLE

Item Specification
Ultra-Clear Spray Glass Cleaner ZC-23 ESR-M14P5-A
  1. Bring the vehicle up to room temperature of at least 16Β°C (60Β°F) or above.
  2. Clean the bus bar in the area to be repaired with steel wool (000 to 0000 grade), and then with glass cleaner to remove all dirt, wax, grease, oil or other foreign material.
    NOTE: The new terminal will cover the original terminal location, but it must be placed so that the terminal conductive areas will be placed on a good conductive base.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.