SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1176 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS - (HYBRID))DTC DIAGNOSISNOTES
2007 Ford Fusion SEL, 2.3 Z, Standard

DTC Diagnosis: Notes

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Notes
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: 'x' equals any number 0 through 9 or letter A through F.

Note 1: Install a new transaxle. Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 .

Note 2: Clear the transaxle control module (TCM) continuous DTCs. Repeat the self-test. If DTC P0613 is present again, install a new transaxle. Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 .

Note 3: Clear the transaxle control module (TCM) continuous DTCs. Repeat the self-test. If DTC P0A1A is present again, install a new transaxle. Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 .

Note 4: Clear the transaxle control module (TCM) continuous DTCs. Carry out a TCM KOEO on demand self-test. If DTC P0A90 is present again, install a new transaxle. Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 . If the DTC is not present, concern can not be duplicated or identified at this time. Go to PPT Z in article 5 for intermittent diagnostics.

Note 5: Check for damaged or seized engine. If the engine is OK, install a new transaxle. Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 .

Note 6: Clear the transaxle control module (TCM) continuous DTCs. Carry out a TCM KOEO on demand self-test. If DTC P0A92 is present again, check for damaged or seized engine, and install a new transaxle. Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 . If the DTC is not present, concern can not be duplicated or identified at this time. Go to PPT Z in article 5 for intermittent diagnostics.

Note 7: DTC P1000 is ignored in the key on, engine off (KOEO) and key on, engine running (KOER) self-tests. Disregard DTC P1000 and continue as directed.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.