Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1166 (PARKING AID)
2007 Ford Fusion SEL, 2.3 Z, Standard
Section 1166 (Parking Aid)
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Section 1166 (Parking Aid)
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnostic Tests
- Parking Aid
- Notes
- Principles of Operation
- Inspection and Verification
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: The Parking Aid Is Inoperative/Does Not Operate Correctly
- Pinpoint Test B: DTCs C1700, C1703, C1706, C1709 - Parking Aid Sensor Circuit Failure or Blockage
- Pinpoint Test C: DTCs C1699, C1702, C1705 and C1708 - Parking Aid Sensor Circuit Short To VBat
- Pinpoint Test D: DTCs C1701, C1704, C1707 and C1710 - Parking Aid Sensor Circuit Fault
- Pinpoint Test E: DTC C1742 and C1743 - Rear Sounder Circuit Short To Vbatt & Rear Sounder Circuit Failure
- Pinpoint Test F: DTC C1748 - Switch Input Circuit Short To Ground
- Pinpoint Test G: DTC C1920 and B2373 - LED #1 Circuit Short to Battery & LED #1 Circuit Failure
- Pinpoint Test H: DTC B1299 - Power Supply Sensor Circuit Short To Ground
- Parking Aid
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.