Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1144 (CLIMATE CONTROL)DESCRIPTION AND OPERATIONAIR CONDITIONINGHIGH-PRESSURE CUTOFF SWITCH
2007 Ford Fusion SEL, 2.3 Z, Standard
High-Pressure Cutoff Switch
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION High-Pressure Cutoff Switch
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
The high-pressure cutoff switch is installed on the compressor-to-condenser discharge line to interrupt A/C compressor operation in the event of high system discharge pressures.
- The high-pressure cutoff switch is mounted on a Schrader-type valve fitting on the A/C compressor discharge line.
- A valve depressor, located inside the threaded end of the high-pressure cutoff switch, presses on the Schrader valve stem.
- This allows the high-pressure cutoff switch to monitor the compressor discharge pressure.
- When the A/C compressor discharge pressure rises, the switch contacts open, disengaging the A/C compressor. When the pressure drops, the contacts close to allow operation of the A/C compressor. Refer to CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS article.
- It is not necessary to recover the refrigerant to remove the high-pressure cutoff switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.