SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1106 (EXTERIOR LIGHTING SYSTEM)DIAGNOSTIC TESTSSTOPLAMPSYMPTOM CHART
2007 Ford Fusion SEL, 2.3 Z, Standard

Symptom Chart

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Symptom Chart
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Symptom Chart

Condition Possible Sources Action
  • All the stoplamp are inoperative
  • Fuse
  • Wiring, terminals or connectors
  • Stoplamp switch
  • Multifunction switch
  • One or more stoplamp are inoperative
  • Wiring, terminals or connectors
  • Bulb holder (non-cutaway vehicles)
  • Rear lamp assembly (cutaway vehicles)
  • High mounted stoplamp
  • Multifunction switch
  • The stoplamp are on continuously
  • Wiring, terminals or connectors
  • Stoplamp switch
  • Multifunction switch
  • Trailer brake control module (TBCM)
  • Brake shift interlock actuator
  • PCM
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.