Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1020 (HVAC CONTROL SYSTEM)REMOVAL AND INSTALLATIONRECEIVER DRIER - HYBRIDNOTES
2007 Ford Fusion SEL, 2.3 Z, Standard
Receiver Drier - Hybrid: Notes
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Notes
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Material
| Item | Specification |
|---|---|
| PAG Refrigerant Compressor Oil (R-134a Systems) YN-12-D |
WSH-M1C231-B |
| Item | Part Number | Description |
|---|---|---|
| 1 | W520413 | Evaporator outlet line fitting nut |
| 2 | W520413 | Auxiliary evaporator outlet line fitting nut |
| 3 | W707137 | Passenger zone valve bracket nut |
| 4 | - | Dual-function pressure switch electrical connector (part of 14290) |
| 5 | W520413 | Auxiliary evaporator inlet line fitting nut |
| 6 | W520413 | Receiver/drier inlet fitting nut |
| 7 | W520413 | Receiver/drier outlet fitting nut |
| 8 | W707137 | Receiver/drier nut (2 required) |
| 9 | 19959 | Receiver/drier |
| 10 | 19B596 | O-ring seal and gasket seal kit |
| 11 | 19B596 | O-ring seal and gasket seal kit (2 required) |
| 12 | 19E889 | O-ring seal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.