SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISP0232 - FUEL PUMP SECONDARY CIRCUIT HIGH
2007 Ford Fusion SEL, 2.3 Z, Standard

P0232 - Fuel Pump Secondary Circuit High

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION P0232 - Fuel Pump Secondary Circuit High
P0232 - FUEL PUMP SECONDARY CIRCUIT HIGH

Description:  The powertrain control module (PCM) monitors the fuel pump monitor (FPM) circuit. This test fails when the PCM detects voltage on the FPM circuit while the fuel pump is commanded OFF. The FPM circuit is wired to a pull-up voltage inside the PCM. The FPM circuit goes high if, with the key ON, engine OFF and the fuel pump commanded OFF, the FPM/FP PWR circuit loses its path to ground through the fuel pump. The FPM circuit also goes high if the FPM/FP PWR circuit is short to voltage.
Possible Causes: 
  • Inertia fuel shutoff (IFS) switch not reset or electrically open
  • Open circuit between the fuel pump and the FPM connection to the FP PWR circuit
  • Poor fuel pump ground
  • Fuel pump electrically open
  • Fuel pump secondary circuits short to voltage
  • Fuel pump relay contacts always closed
  • Open FPM circuit between the PCM and the connection to the FP PWR circuit
Diagnostic Aids:  Continuous memory P0232 can be set if the IFS switch is tripped then reset, or if the fuel pump circuit is activated when the PCM expected the circuit to be off. This DTC may set during a fuel system test or prime procedure.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All refer to PINPOINT TEST KA .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.