Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONWHEEL ALIGNMENTSUSPENSION SYSTEM - GENERAL INFORMATIONDIAGNOSTIC TESTSSUSPENSION SYSTEMINSPECTION AND VERIFICATION
2007 Ford Fusion SEL, 2.3 Z, Standard
Inspection and Verification
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Inspection and Verification
- Road test the vehicle.
- Verify the customer's concern by carrying out a road test on a smooth road.
- Inspect the tires.
- Check the tire pressure with all normal loads in the vehicle and the tires cold. Refer to the Vehicle Certification (VC) label.
- Verify that all tires are sized to specification.
- Inspect the tires for incorrect wear and damage.
- Inspect the chassis and underbody.
- Remove any excessive accumulation of mud, dirt or road deposits from the chassis and underbody.
- Inspect for aftermarket equipment.
- Check for aftermarket changes to the steering, suspension wheel and tire components (such as competition or heavy duty). The specifications shown in this manual do not apply to vehicles equipped with aftermarket equipment.
VISUAL INSPECTION CHARTMechanical - Front wheel bearing(s)
- Loose or damaged front or rear suspension components
- Loose, damaged or missing suspension fastener(s)
- Damaged or leaking shocks(s)
- Worn or damaged suspension bushing(s)
- Loose, worn or damaged steering system components
- Damaged axle components
- If an obvious cause for an observed or reported condition is found, correct the cause (if possible) before proceeding to the next step.
- If the fault is not visually evident, determine the symptom. Go to Symptom Chart .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.