Fuel Pump (FP) Module

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Fuel Pump (FP) Module

The FP module is a device that contains the fuel pump and sender assembly. The fuel pump is located inside the FP module reservoir and supplies fuel through the FP module manifold to the engine and FP module jet pump. The jet pump continuously refills the reservoir with fuel, and a check valve located in the manifold outlet maintains system pressure when the fuel pump is not energized. A flapper valve located in the bottom of the reservoir allows fuel to enter the reservoir and prime the fuel pump during the initial fill.

Fig 1: Typical Electronic Returnless Fuel Pump (FP) Module
GF0001449
Item Part Number Description
1 - Fuel Level Float
2 - Fuel Intake Filter
3 - Fuel Supply
Fig 2: Typical Mechanical Returnless Fuel Pump (FP) Module
GF0001450
Item Part Number Description
1 - Fuel Level Float
2 - Fuel Intake Filter
3 - Fuel Supply
4 - Fuel Return from Fuel Filter
5 - Fuel Pressure Regulator
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.