Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSSEATINGREMOVAL AND INSTALLATIONCLIMATE CONTROLLED SEAT MODULEINSTALLATION
2007 Ford Fusion SEL, 2.3 Z, Standard
Climate Controlled Seat Module: Installation
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Installation
- Install the DCSM to the seat.
- Position the DCSM to the electrical bracket and install 2 new rivets.
- Connect the 3 DCSM electrical connectors and locking wedges.
- Install the front seat and repower the SRS. Do not prove out the SRS at this time. For additional information, refer to Seat - Front .
- Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test. For additional information, refer to the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
- After installing the DCSM, carry out the appropriate steps in the PMI procedure. For additional information, refer to MODULE CONFIGURATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.