Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2007FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 89 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM -- F250-F550 SUPER DUTY)REMOVAL AND INSTALLATIONPASSENGER AIR BAG MODULEINSTALLATION

2007 Ford Focus SES, 4D Sedan, Standard

Passenger Air Bag Module: Installation

2007 Ford Focus SES, 4D Sedan, StandardSECTION Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Position the passenger air bag module into the instrument panel. Install the passenger air bag module retaining nuts and bolts.

Fig 1: Installing Passenger Air Bag Module Retaining Nuts And Bolts - With Torque Specifications
Courtesy of FORD MOTOR CO.
Install the passenger air bag module door.
- Align the passenger air bag module door and push in seating the retaining clips.
  - Place six new offset fasteners onto the deployment door.
    
    Fig 2: Installing Passenger Air Bag Module Door
    Courtesy of FORD MOTOR CO.
Connect the passenger air bag module electrical connector.

Fig 3: Locating Passenger Air Bag Module Electrical Connector
Courtesy of FORD MOTOR CO.
Close the glove compartment.
Repower the system. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING in this article.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.