Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 862 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS - (HYBRID))DTC DIAGNOSISP0320 - IGNITION/DISTRIBUTOR ENGINE SPEED INPUT CIRCUIT
2007 Ford Focus SES, 4D Sedan, Standard
P0320 - Ignition/Distributor Engine Speed Input Circuit
2007 Ford Focus SES, 4D Sedan, StandardSECTION P0320 - Ignition/Distributor Engine Speed Input Circuit
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
P0320 - IGNITION/DISTRIBUTOR ENGINE SPEED INPUT CIRCUIT
| Description: | The ignition engine speed sensor input signal to powertrain control module (PCM) is continuously monitored. The test fails when the signal indicates that 2 successive erratic profile ignition pickup (PIP) pulses occurred. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | The DTC indicates that 2 successive erratic PIP pulses occurred. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | - | - | refer to PINPOINT TEST NC . | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.