Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1627 (ENGINE CONTROLS - PINPOINT TEST KE: IDLE AIR CONTROL (IAC) VALVE THROUGH PINPOINT TEST Z: INTERMITTENT - (EXCEPT DIESEL & HYBRID))PINPOINT TEST QD: DTC P1260: PASSIVE ANTI-THEFT SYSTEMINTRODUCTION
2007 Ford Focus SES, 4D Sedan, Standard
Pinpoint Test QD: DTC P1260: Passive Anti-Theft System: Introduction
2007 Ford Focus SES, 4D Sedan, StandardSECTION Introduction
WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Milan, and 2006 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The passive anti-theft system (PATS) uses radio frequency identification technology to deter a drive away theft. Passive means that it does not require any activity from the user. The PATS uses a specially encoded ignition key. Each encoded ignition key contains a permanently installed electronic device called a transponder. Each transponder contains a unique electronic identification code. Each encoded ignition key must be programmed into the vehicle before it can be used to start the engine. DTC P1260 is stored any time the PCM disables the vehicle because of the PATS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.