Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FOCUS SES, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISP0108 - MANIFOLD ABSOLUTE PRESSURE (MAP)/BAROMETRIC PRESSURE (BARO) SENSOR HIGH
2007 Ford Focus SES, 4D Sedan, Standard
P0108 - Manifold Absolute Pressure (Map)/Barometric Pressure (BARO) Sensor High
2007 Ford Focus SES, 4D Sedan, StandardSECTION P0108 - Manifold Absolute Pressure (Map)/Barometric Pressure (BARO) Sensor High
P0108 - MANIFOLD ABSOLUTE PRESSURE (MAP)/BAROMETRIC PRESSURE (BARO) SENSOR HIGH
| Description: | Sensor operating voltage is greater than 5 volts (VREF). As a result it failed above the maximum allowable calibrated parameter. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | VREF should be greater than 4.0 volts. The PID reading is in frequency/volts. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST DM . | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.