Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FOCUS L4-2.3L VIN ZREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW GLASSFRONT DOOR WINDOW GLASSSERVICE AND REPAIR
2007 Ford Focus L4-2.3L VIN Z
Front Door Window Glass: Service and Repair
2007 Ford Focus L4-2.3L VIN ZSECTION Service and Repair
WINDOW GLASS - FRONT DOOR
Exploded View
Removal and Installation
All vehicles
1. Remove the front door speaker.
2. Remove the side impact bolster.
3. Position the door latch release handle aside.
4. CAUTION: Do not touch the adhesive surface, as re-bonding will be impaired.
Remove the wathershield.
Vehicles with power windows
5. Remove the retainers and position the one-touch down relay aside.
6. Connect the window control switch electrical connector.
Vehicles with manual windows
7. Install the window regulator handle.
All vehicles
8. Remove the 2 door window glass clamp bolts.
- To install, tighten to 8 Nm (71 lb-in).
9. Hold the window glass at the top of the opening, lower the regulator and remove the window glass from the regulator.
10. Remove the window glass.
1 Lift the glass.
2 Tip the glass forward and remove the glass from the front of the door.
11. To install, reverse the removal procedure.
Exploded View
Removal and Installation
All vehicles
1. Remove the front door speaker.
2. Remove the side impact bolster.
3. Position the door latch release handle aside.
4. CAUTION: Do not touch the adhesive surface, as re-bonding will be impaired.
Remove the wathershield.
Vehicles with power windows
5. Remove the retainers and position the one-touch down relay aside.
6. Connect the window control switch electrical connector.
Vehicles with manual windows
7. Install the window regulator handle.
All vehicles
8. Remove the 2 door window glass clamp bolts.
- To install, tighten to 8 Nm (71 lb-in).
9. Hold the window glass at the top of the opening, lower the regulator and remove the window glass from the regulator.
10. Remove the window glass.
1 Lift the glass.
2 Tip the glass forward and remove the glass from the front of the door.
11. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.