Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Throttle Body (ETB) Position Sensor
2007 Ford Focus L4-2.3L VIN ZSECTION Electronic Throttle Body (ETB) Position Sensor
ELECTRONIC THROTTLE BODY (ETB) POSITION SENSOR
The ETB position sensor has 2 signal circuits in the sensor for redundancy. The redundant ETB position signals are required for increased monitoring. The first ETB position sensor signal (TP1) has a negative slope (increasing angle, decreasing voltage) and the second signal (TP2) has a positive slope (increasing angle, increasing voltage). During normal operation the negative slope ETB position sensor signal (TP1) is used by the control strategy as the indication of throttle position. The 2 ETB position sensor signals make sure the PCM receives a correct input even if 1 signal has a concern. There is 1 reference voltage circuit and 1 signal return circuit for the sensor.
The ETB position sensor has 2 signal circuits in the sensor for redundancy. The redundant ETB position signals are required for increased monitoring. The first ETB position sensor signal (TP1) has a negative slope (increasing angle, decreasing voltage) and the second signal (TP2) has a positive slope (increasing angle, increasing voltage). During normal operation the negative slope ETB position sensor signal (TP1) is used by the control strategy as the indication of throttle position. The 2 ETB position sensor signals make sure the PCM receives a correct input even if 1 signal has a concern. There is 1 reference voltage circuit and 1 signal return circuit for the sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.