Steering Gear Valve Test

2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Steering Gear Valve Test
  1. With the vehicle in motion, place the transmission in NEUTRAL and turn the engine OFF.
    • If the vehicle does not pull with the engine OFF, repair or install a new steering gear. Refer to the appropriate Steering System article for the procedure.
  2. If the vehicle pulls with the engine OFF, switch the right side front wheel to the left side of the vehicle and the left side front wheel to the right side of the vehicle.
  3. If the vehicle pulls to the opposite side, switch the front wheels with the rear wheels keeping them on the same side of the vehicle.
  4. If the vehicle pull direction does not change, check the front suspension components, wheel alignment and frame alignment. Refer to the appropriate Suspension article for the procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.