Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGPOWER STEERING SYSTEMREMOVAL AND INSTALLATIONPOWER STEERING PUMP PULLEY - 2.3LINSTALLATION

2007 Ford Escape Base, 2.3 Z, FWD, Automatic

Power Steering Pump Pulley - 2.3L: Installation

2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Installation

NOTE: Make sure the pulley is flush with the end of the power steering pump shaft.

Using the special tool, install the power steering pump pulley.

Fig 1: Installing Power Steering Pump Pulley

Courtesy of FORD MOTOR CO.

Position the A/C manifold tube assembly bracket and install the 2 nuts.
- Tighten to 8 Nm (71 lb-in).
Rotate the accessory drive belt tensioner clockwise and install the accessory drive belt.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.