Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS - (HYBRID))DTC DIAGNOSISU0418 - INVALID DATA RECEIVED FROM BRAKE SYSTEM CONTROL MODULE
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
U0418 - Invalid Data Received From Brake System Control Module
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION U0418 - Invalid Data Received From Brake System Control Module
WARNING: This page is about a different variant/trim than selected.
U0418 - INVALID DATA RECEIVED FROM BRAKE SYSTEM CONTROL MODULE
| Description: | The powertrain control module (PCM) continuously monitors controller area network (CAN) for messages from the anti-lock brake system (ABS) module. This DTC is set when the PCM does not receive the ABS message within a defined time period, or when the message received is out of expected range, or if the message received contains invalid data. When this DTC is set the regenerative braking is disabled until the next driving cycle. | |||
| Possible Causes: | See the possible causes for DTC U0073. | |||
| Diagnostic Aids: | See the diagnostic aids for DTC U0001. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | Refer to MODULE COMMUNICATIONS NETWORK . | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.