P1299 - Cylinder Head Over Temperature Protection Active

2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION P1299 - Cylinder Head Over Temperature Protection Active
WARNING: This page is about a different variant/trim than selected.
P1299 - CYLINDER HEAD OVER TEMPERATURE PROTECTION ACTIVE

Description:  Indicates an engine overheat condition was detected by the cylinder head temperature (CHT) sensor. An FMEM strategy called fail-safe cooling was activated to cool the engine.
Possible Causes: 
  • Engine cooling system concerns
  • Low engine coolant level
  • Base engine concerns
Diagnostic Aids:  Refer toPOWERTRAIN CONTROL SOFTWARE , for more information on the fail-safe cooling strategy and the CHT sensor.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All   - refer to PINPOINT TEST DL . refer to PINPOINT TEST DL .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.