Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS - (HYBRID))DTC DIAGNOSISP1145 (TCM) - CALCULATED TORQUE ERROR
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
P1145 (TCM) - Calculated Torque Error
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION P1145 (TCM) - Calculated Torque Error
WARNING: This page is about a different variant/trim than selected.
P1145 (TCM) - CALCULATED TORQUE ERROR
| Description: | The transaxle control module (TCM) continuously monitors the controller area network (CAN) for calculated torque message from the powertrain control module (PCM). This DTC is set when the calculated torque is not within the expected range. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | Monitor the TCM TQ_DSD PID. The PID value should be positive in DRIVE or LOW, negative in REVERSE, 0 Nm (0 lb ft) in PARK or NEUTRAL if the brake pedal is not applied. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST TU . | - | refer to PINPOINT TEST TU . | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.