Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 38 (ANTI-THEFT SYSTEM - PATS - (HYBRID))GENERAL PROCEDURESKEY PROGRAMMING SWITCH STATE CONTROLUNLIMITED KEY MODE PROGRAMMINGDISABLING UNLIMITED KEY MODE
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Disabling Unlimited Key Mode
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Disabling Unlimited Key Mode
WARNING: This page is about a different variant/trim than selected.
- Using a scan tool, select PCM from the menu. Follow SECURITY ACCESS to obtain security access. For additional information, refer to Anti-Theft Security Access .
- Select: DISABLE UNLIMITED KEY MODE.
- Select: IGNITION KEY CODE ERASE and RESET procedure BIT if applicable.
- Disconnect the scan tool and turn the ignition OFF.
- Program 2 keys to enable the vehicle.
- Program any additional keys. For additional information, refer to Key Programming Using Two Programmed Keys or Key Programming Using Diagnostic Equipment .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.