Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 16 (ELECTRONIC ENGINE CONTROLS - 2.3L - (HYBRID))SPECIFICATIONSTORQUE SPECIFICATIONS
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Torque Specifications
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Catalyst monitor sensors | 48 | 35 | - |
| Crankshaft position (CKP) sensor boltsa | - | - | - |
| Engine plug bolt | 20 | 15 | - |
| Ground strap nut | 6 | - | 53 |
| Heated oxygen sensors (HO2S) | 48 | 35 | - |
| Knock sensor (KS) bolt | 20 | 15 | - |
| Mass air flow (MAF) sensor screws | 10 | - | 89 |
| Powertrain control module (PCM) stud bolts | 6 | - | 53 |
| Wiring harness retaining nut | 6 | - | 53 |
a Refer to the procedure for specification.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.