Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 987 (SEATING)REMOVAL AND INSTALLATIONSEAT ARMREST - FRONT
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Seat Armrest - Front
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Seat Armrest - Front
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
LH shown, RH similar.
- Remove the armrest.
- Release the hook-and-loop at the rear of the armrest trim cover and access the armrest bolt.
- Remove the armrest bolt and crown washer.
- To install, tighten to 35 Nm (26 lb-ft).
- Remove the armrest.
- To install, reverse the removal procedure.
NOTE:
Install a new crown washer when re-installing the armrest.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.