Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 947 (POWER TRANSFER UNIT (PTU))IN-VEHICLE SERVICINGTRANSFER CASE VENTREMOVAL
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Transfer Case Vent: Removal
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Removal
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure applies to vehicles equipped with manual transaxles.
- Remove the power transfer unit (PTU). For additional information, refer to Power Transfer Unit (PTU) - Manual Transaxle in the Removal portion of this article.
- Using a slide hammer with a 3-jaw puller attachment, remove the PTU tube.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.