Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 877 (SUNROOF)REMOVAL AND INSTALLATIONROOF OPENING PANEL GLASS
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Roof Opening Panel Glass
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Roof Opening Panel Glass
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Open the roof opening panel to the VENT position.
- Remove the 4 roof opening panel glass screws and the roof opening panel glass.
- To install tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
- Verify that the roof opening panel is centered and aligned before tightening the bolts. For additional information, refer to Roof Opening Panel Alignment .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.