Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Autolock Enable/Disable - Using the Keyless Entry Keypad
A manual enable/disable mode allows the autolock feature to be turned off and on.
To enable or disable autolock using the keyless entry keypad:
- Enter the 5-digit permanent entry code into the keyless entry keypad.
- Within 5 seconds of entering the code, press and hold the 7/8 button on the keyless entry keypad.
- Within 5 seconds of Step 2, and while holding the 7/8 button, press the 3/4 button on the keyless entry keypad and release it.
- Within 5 seconds of Step 3, release the 7/8 button on the keyless entry keypad.
If the autolock feature is disabled, the horn chirps once. If the autolock feature is enabled, the horn chirps once shortly and then sounds a second time for a longer duration.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.