Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 479 (EXTERIOR LIGHTING SYSTEM)DIAGNOSIS AND TESTINGAUTOLAMPSSYMPTOM CHART

2007 Ford Escape Base, 2.3 Z, FWD, Automatic

Symptom Chart

2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Symptom Chart

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

SYMPTOM CHART

Condition	Possible Sources	Action
The autolamps are inoperative - do not operate correctly	Fuse Circuitry Light sensor Headlamp switch Vehicle security module	GO to PINPOINT TEST G .
The autolamps are on continuously	Light sensor covered by opaque material/obstructed	REMOVE the opaque material/obstruction.
	Light sensor incorrectly installed	INSTALL the light sensor correctly.
	Circuitry Light sensor Vehicle security module	GO to PINPOINT TEST G .
The autolamp time delay is inoperative	Vehicle security module	INSTALL a new vehicle security module. REFER to MULTIFUNCTION ELECTRONIC MODULES .
The headlamps are inoperative with autolamps on	Fuse Circuitry Vehicle security module	GO to PINPOINT TEST G .
The autolamps operate, but parking, rear or license plate lamps are inoperative	Fuse Circuitry Vehicle security module	GO to PINPOINT TEST G .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.