SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 385 (EXTERIOR LIGHTING SYSTEM)DIAGNOSIS AND TESTINGHEADLAMPSSYMPTOM TABLE
2007 Ford Escape Base, 2.3 Z, FWD, Automatic

Symptom Table

2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Symptom Table
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
HEADLAMP SYMPTOM TABLE

Condition Possible Sources Action
  • Both headlamps are inoperative
  • Fuse
  • Circuitry
  • Multifunction switch
  • Smart junction box (SJB)
  • The low beams are inoperative
  • Fuse
  • Circuitry
  • Multifunction switch
  • SJB
  • The high beams are inoperative
  • Fuse
  • Circuitry
  • Multifunction switch
  • SJB
  • One low beam headlamp is inoperative
  • Circuitry
  • SJB
  • One high beam headlamp is inoperative
  • Circuitry
  • SJB
  • The headlamps are on continuously
  • Circuitry
  • Multifunction switch
  • SJB
  • The flash-to-pass feature is inoperative
  • Circuitry
  • Multifunction switch
  • SJB
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.