Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 379 (INSTRUMENT CLUSTER SYSTEM)REMOVAL AND INSTALLATIONINSTRUMENT CLUSTERREMOVAL AND INSTALLATION
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Removal and Installation
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
- Lower the tilt steering column to the lowest position.
- Remove the 2 screws and the instrument cluster finish panel.
- Remove the 4 instrument cluster screws and the instrument cluster.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.
- Download the instrument cluster configuration information from the scan tool into the new instrument cluster. For additional information, refer to MODULE CONFIGURATION .
NOTE:
Prior to removal of the module, it is necessary to upload the module configuration information to the scan tool. For additional information, refer to
MODULE CONFIGURATION
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.