Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 377 (ANTI-LOCK BRAKE SYSTEM - VEHICLE DYNAMIC SYSTEMS)REMOVAL AND INSTALLATIONACCELEROMETER - HYBRIDREMOVAL AND INSTALLATION
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Removal and Installation
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The traction battery and charging system contain high voltage components and wiring. High voltage insulated safety gloves and a face shield must be worn when carrying out any diagnostics on this vehicle. Failure to follow these instructions may result in severe personal injury or death.
- Disconnect the battery. For additional information, refer to BATTERY DISCONNECT .
- Depower the high voltage battery. For additional information, refer to HIGH-VOLTAGE TRACTION BATTERY SYSTEMS DEPOWERING .
- Remove the floor console. For additional information, refer to REMOVAL AND INSTALLATION .
- Disconnect the electrical connector.
- Remove the 2 accelerometer nuts.
- To install, tighten to 7 N.m (62 lb-in).
- Remove the accelerometer.
- To install, reverse the removal procedure.
NOTE:
When installing the accelerometer the electrical connector must face the driver seat.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.