Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 259 (ACCESSORY DRIVE SYSTEM)DIAGNOSIS AND TESTINGACCESSORY DRIVEINSPECTION AND VERIFICATION
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Inspection and Verification
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Inspection and Verification
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Under no circumstances should the accessory drive belt, tensioner or pulleys be lubricated as potential damage to the belt material and tensioner damping mechanism will occur. Do not apply any fluids or belt dressing to the accessory drive belt or pulleys.
- Verify the customer concern by operating the system.
- Visually inspect for obvious signs of mechanical damage.VISUAL INSPECTION CHART
Mechanical - Drive belt cracking/chunking/wear
- Belt/pulley contamination
- Incorrect accessory drive belt
- Incorrectly routed accessory drive belt
- Pulley misalignment or excessive pulley runout
- Loose or mislocated hardware
- Incorrectly routed power steering tubes (rubbing)
- Loose accessory drive belt
- Damaged pulleys
- Tensioner arm misalignment
NOTE: Modular engine (without A/C) belt tensioner shown, others similar.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.