Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 186 (SEAT SYSTEM)REMOVAL AND INSTALLATIONSEAT - THIRD ROWREMOVAL AND INSTALLATION

2007 Ford Escape Base, 2.3 Z, FWD, Automatic

Removal and Installation

2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Seat Components

Courtesy of FORD MOTOR CO.

Remove the left and right side rear quarter trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

NOTE: 50/50 seat shown, bench seat similar.

Remove the 2 load floor supports (1 shown) from the load floor panel(s).
- Push the load floor support back and lift up on the load floor to disengage.
  
  Fig 2: Pushing Load Floor Support Back And Lift Up On Load Floor To Disengage
  Courtesy of FORD MOTOR CO.
Remove the 4 bolts and remove the third row seat.
- To install, tighten to 80 Nm (59 lb-ft).
To install, reverse the removal procedure.
- Make sure the safety belt buckles are accessible to the occupants after installation.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.