Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 175 (EXTERIOR LIGHTING SYSTEM)DIAGNOSIS AND TESTINGFOG LAMPSINSPECTION AND VERIFICATIONSMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Smart Junction Box (SJB) Diagnostic Trouble Code (DTC) Index
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Smart Junction Box (SJB) Diagnostic Trouble Code (DTC) Index
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description | Action |
|---|---|---|
| B1342 | ECU is Faulted | CLEAR the DTCs. RETRIEVE the DTCs. If DTC B1342 is retrieved again, INSTALL a new SJB. REFER to MULTIFUNCTION ELECTRONIC MODULES . |
| B2030 | Front Fog Lamp Relay Circuit Failure | If the fog lamps are inoperative, GO to PINPOINT TEST T . If the fog lamps are always on, GO to PINPOINT TEST V . |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.