Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1437 (STEERING COLUMN)REMOVAL AND INSTALLATIONSTEERING WHEEL BEZELINSTALLATION
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Steering Wheel Bezel: Installation
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carefully install the bezel onto the steering wheel as instructed or damage to the bezel can occur.
- Position the bezel onto the steering wheel and align the 10 pins with their respective holes.
-
NOTE: The bezel is installed in 2 stages. Stage 1 seats the 10 pins into the steering wheel approximately half-way. Stage 2 fully seats the 10 pins into the steering wheel.
Beginning with the upper RH corner and continuing in a clockwise direction, push the bezel onto the steering wheel until the pins are seated approximately half-way into the holes.
- Beginning with the upper RH corner and continuing in a clockwise direction, push the bezel onto the steering wheel until the pins are fully seated into the holes.
- Install the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM -- FUSION, MILAN & MKZ article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.