Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1381 (AUTOMATIC TRANSAXLE - AISIN AW21)DIAGNOSIS AND TESTINGPRELIMINARY INSPECTIONCHECK TRANSMISSION FLUID LEVEL AND CONDITIONTRANSMISSION FLUID LEVEL CHECK
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Transmission Fluid Level Check
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Transmission Fluid Level Check
WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Transmission fluid should be checked at normal operating temperature 60°C-70°C (140°F-158°F) on a level surface. Normal operating temperature is reached after approximately 32 km (20 mi) of driving and can be checked using the scan tool.
Check the transmission fluid level during normal maintenance. If the transaxle starts to slip, shifts slowly or shows signs of transmission fluid leaking, the transmission fluid level should be checked.
- With the selector lever in PARK, engine at idle, brake pedal applied, move the selector lever through each gear range and allow engagement of each gear. Place the selector lever in the PARK position.
- Wipe the transmission fluid level indicator cap and remove the transmission fluid level indicator.
- Wipe the transmission fluid level indicator with a clean cloth.
- Install the transmission fluid level indicator back in the transmission fluid filler tube until it is fully seated, then remove the indicator. The transmission fluid level should be within the normal operating range.
ITEM DESCRIPTION
| Item | Description |
|---|---|
| 1 | Transmission fluid level at operating temperature 60°C-70°C (140°F-158°F) |
| 2 | Transmission fluid level cold 15°C-25°C (59°F-77°F) |
| 3 | Do not drive mark |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.