Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1237 (ENGINE CONTROLS - ELECTRONIC ENGINE CONTROLS - 3.0L (4V))REMOVAL AND INSTALLATIONCYLINDER HEAD TEMPERATURE (CHT) SENSOR
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Cylinder Head Temperature (CHT) Sensor
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Cylinder Head Temperature (CHT) Sensor
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
ITEM DESCRIPTION CHART
| Item | Part Number | Description |
|---|---|---|
| 1 | 14A464 | Cylinder Head Temperature (CHT) sensor electrical connector (part of 12C508) |
| 2 | 6G004 | CHT sensor |
NOTE:
If the cylinder head is being replaced, the CHT
must be replaced.
- Disconnect the Cylinder Head Temperature (CHT) sensor electrical connector.
- Remove the CHT
sensor.
- To install, tighten to 11 Nm (97 lb-in).
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.