Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1218 (ANTI-LOCK BRAKE SYSTEM - VEHICLE DYNAMIC SYSTEMS)REMOVAL AND INSTALLATIONHYDRAULIC CONTROL UNIT (HCU)SPECIAL TOOL(S)
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Special Tool(s)
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Special Tool(s)
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL(S) SPECIFICATION
| Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool |
PART DESCRIPTION CHART
| Item | Part Number | Description |
|---|---|---|
| 1 | W712119 | Hydraulic Control Unit (HCU) bracket-to-frame bolt (3 required) |
| 2 | 2C215 | HCU |
| 3 | - | Master cylinder secondary brake tube fitting (part of 2268) |
| 4 | - | Master cylinder primary brake tube fitting (part of 2268) |
| 5 | - | LH front brake tube fitting (part of 2264) |
| 6 | - | RH front brake tube fitting (part of 2263) |
| 7 | - | Rear brake tube fittings (part of 2267) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.