SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1159 (WINDOWS AND GLASS - GLASS, FRAMES AND MECHANISMS)GENERAL PROCEDURESWINDOW MOTOR INITIALIZATIONDE-INITIALIZATION PROCEDURE
2007 Ford Escape Base, 2.3 Z, FWD, Automatic

De-Initialization Procedure

2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION De-Initialization Procedure
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition key ON.
  2. Operate the window control switch in one-touch up mode and remove power from the window motor while the window is moving  by one of the following methods:
    1. Disconnect the vehicle battery cable while the window is moving  .
    2. Disconnect the window motor connector while the window is moving  .
    3. Remove the LH or RH front window motor fuse while the window is moving  .
  3. This will de-initialize the window motor and reset the window motor to its original factory settings.
  4. Reconnect the battery cable, window motor connector or window motor fuse before proceeding to the initialization procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.