SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1084 (HVAC - CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS (HYBRID))SPECIFICATIONSGENERAL SPECIFICATIONS TABLE
2007 Ford Escape Base, 2.3 Z, FWD, Automatic

General Specifications Table

2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION General Specifications Table
WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS TABLE

Item Specification
A/C Compressor Oil 
NOTE: Use of any Air Conditioning (A/C) compressor oil other than what is specified for the specific vehicle configuration will damage the A/C compressor and contaminate the refrigerant system. For non-hybrid vehicles with a pulley driven (conventional) A/C compressor, PAG Refrigerant Compressor Oil only must be used. For hybrid vehicles with an electric A/C compressor, Motorcraft® Electric A/C Compressor Oil must be used.
A/C Pressure Relief Valve (1)
Close pressure 3,103 kPa (450 psi)
Open pressure 3,792-4,137 kPa (550-600 psi)
(1) Manifold gauge set pressures may vary slightly depending on the distance between the service gauge port valve and the A/C pressure relief valve, the A/C cycling switch or the pressure cutoff switch location.
NOTE: The specifications apply to hybrid vehicles only. For non-hybrid specifications, refer to CLIMATE CONTROL SYSTEM .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.