Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1057 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DTC DIAGNOSISDTC P164B: O2 SENSOR POSITIVE CURRENT TRIM CIRCUIT PERFORMANCE (BANK 2 SENSOR 1)
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
DTC P164B: O2 Sensor Positive Current Trim Circuit Performance (Bank 2 Sensor 1)
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION DTC P164B: O2 Sensor Positive Current Trim Circuit Performance (Bank 2 Sensor 1)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P164B: O2 SENSOR POSITIVE CURRENT TRIM CIRCUIT PERFORMANCE (BANK 2 SENSOR 1)
| Description: | See the description for DTC P164A . | ||
| Possible Causes: | See the description for DTC P164A . | ||
| Diagnostic Aids: | See the description for DTC P164A . | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DZ . | - | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.