Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1049 (ENGINE CONTROLS - DIAGNOSTIC METHODS - (HYBRID))PARAMETER IDENTIFICATION (PID)FORD TCM PID LIST
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Ford TCM PID List
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Ford TCM PID List
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
FORD TCM PID LIST
| Acronym | Description | Manufacturer Units |
|---|---|---|
| ENG_CTO | Vehicle Speed TCM Received | RPM |
| ENG_TQ | Engine Torque | Nm |
| ENGRPMA | Engine Speed TCM | RPM |
| CONTACT | Traction Battery Contactor Status TCM Received | OPEN/CLOSED |
| GCLTEMP | Generator Motor Coil Temperature | DEGREES |
| GENMODE | Generator Operational Mode | MODE |
| GTQ_CMD | Measured Generator Motor Torque | Nm |
| GTQ_OUT | Desired Generator Motor Torque TCM Received | Nm |
| G_INV_V | Actual Generator Motor Inverter Voltage | VOLTS |
| G_PHTMP | Generator Inverter Phase Temperature (Highest of 3 Phases) | DEGREES |
| G_SDN_A | Generator Motor Shutdown from TCM | ShutDwn/Not ShutDwn |
| G_SDN_B | Generator Motor Shutdown from VSC | ShutDwn/Not ShutDwn |
| G_SDN_C | Generator Motor Shutdown from PCM | ShutDwn/Not ShutDwn |
| G_SPEED | Generator Motor Speed | RPM |
| HV_AMP | Traction Battery Current TCM Received Through Communication Network | AMPERES |
| HVBAT_V | Traction Battery Voltage TCM Received | VOLTS |
| I_SDN_1 | Immediate Shutdown 1 Input | CHARGE/DISCHARGE |
| I_SDN_2 | Immediate Shutdown 2 Input | CHARGE/DISCHARGE |
| MCLTEMP | Traction Motor Coil Temperature | DEGREES |
| MECT | Motor Electronics Coolant Temperature | DEGREES |
| M_SDN_A | Traction Motor Shutdown from TCM | ShutDwn/Not ShutDwn |
| M_SDN_B | Traction Motor Shutdown from VSC | ShutDwn/Not ShutDwn |
| M_SDN_C | Traction Motor Shutdown from PCM | ShutDwn/Not ShutDwn |
| MTQ_CMD | Desired Traction Motor Torque | Nm |
| MTQ_OUT | Measured Traction Motor Torque | Nm |
| M_INV_V | Actual Traction Motor Inverter Voltage | VOLTS |
| M_PHTMP | Traction Motor Inverter Temperature (Highest of 3 Phases) | DEGREES |
| M_SPEED | Traction Motor Speed | RPM |
| PRNDL_T | Gear Selector Position | Selector Position |
| RPM_DSD | Desired Engine Speed TCM | RPM |
| TCM_CAU | Powertrain Malfunction Indicator (Wrench) Commanded | ON/OFF |
| TCM_HAZ | Hazard Indicator Commanded | ON/OFF |
| TOT | Transmission Oil Temperature | Degrees |
| TQ_DSD | Desired Torque TCM Received | Nm |
| VBAT | Vehicle Power Voltage | VOLTS |
| VEHMODE | Vehicle Operational Mode TCM Received | MODE |
| VSS_TCM | Vehicle Speed TCM Calculated | Km/h/MPH |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.