Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1005 (ENGINE - 4.6L AND 5.4L)IN-VEHICLE SERVICINGINTAKE MANIFOLD - 5.4LNOTES
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Intake Manifold - 5.4L: Notes
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Notes
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Material
| Item | Specification |
|---|---|
| Motorcraft Metal Surface Prep ZC-31 |
- |
| Silicone Gasket Remover ZC-30 |
- |
| Item | Part Number | Description |
|---|---|---|
| 1 | 6K817 | PCV tube |
| 2 | N807309 | Generator support bracket bolt (3 required) |
| 3 | 10153 | Generator support bracket |
| 4 | 6758 | Crankcase vent tube |
| 5 | - | Upper radiator hose |
| Item | Part Number | Description |
|---|---|---|
| 1 | N806178 | Thermostat housing bolts (2 required) |
| 2 | 8594 | Thermostat housing |
| 3 | N806807 | Thermostat housing O-ring seal |
| 4 | 8575 | Thermostat |
| 5 | W503300 | Intake manifold bolt (9 required) |
| 6 | N606500 | Ignition coil bolt (8 required) |
| 7 | 12A366 | Ignition coil (8 required) |
| 8 | 9S455 | Intake manifold |
| 9 | 9439 | Intake manifold gaskets (2 required) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.