Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - PINPOINT TEST HG: POSITIVE CRANKCASE VENTILATION (PCV) SYSTEM THROUGH PINPOINT TEST JD: CRANKSHAFT POSITION (CKP) SENSOR - (EXCEPT DIESEL & HYBRID)
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Engine Controls - Pinpoint Test Hg: Positive Crankcase Ventilation (PCV) System Through Pinpoint Test JD: Crankshaft Position (CKP) Sensor - (Except Diesel & Hybrid)
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Engine Controls - Pinpoint Test Hg: Positive Crankcase Ventilation (PCV) System Through Pinpoint Test JD: Crankshaft Position (CKP) Sensor - (Except Diesel & Hybrid)
- PINPOINT TEST HG: Positive Crankcase Ventilation (PCV) System
- PINPOINT TEST HH: Exhaust Gas Recirculation System Module (ESM)
- PINPOINT TEST HK: Variable Camshaft Timing (VCT)
- PINPOINT TEST HM: Secondary Air Injection (AIR) System
- PINPOINT TEST HU: Intake Air Systems
- PINPOINT TEST HV: Cooling Fan Clutch
- PINPOINT TEST HX: Evaporative Emission (EVAP) System and Monitor
- PINPOINT TEST HY: Generator/Regulator System
- PINPOINT TEST JB: Secondary Ignition (COP)
- PINPOINT TEST JC: Secondary Ignition (Coil Pack)
- PINPOINT TEST JD: Crankshaft Position (CKP) Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.