Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE SYSTEM - GENERAL INFORMATIONDIAGNOSTIC TESTSBRAKE SYSTEMINSPECTION AND VERIFICATIONBRAKE PADS
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Brake Pads
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Brake Pads
NOTE:
New brake pads are not required if the friction material properties are within the guidelines. New brake pads are not required when the brake discs are machined.
- Remove the brake pads. Refer to FRONT DISC BRAKE article for front disc brakes or REAR DISC BRAKE article for rear disc brakes.
- Inspect and measure the thickness of the brake pad friction material.
- Install new brake pads if the thickness of the friction material is less than 3 mm (0.118 in).
- Compare all four front or rear pads for uneven wear. Install new brake pads if the thickness of the friction material varies from pad to pad by more than 2 mm (0.079 in).
- Install new brake pads if there are missing pieces or cracks in the lining through the backing plate.
- If the friction material shows taper wear (for example: the thickness varies by more than 3 mm (0.118 in) any direction), or if the pads show uneven wear (2 mm (0.079 in) difference between the inboard and the outboard pad), verify the caliper guide pins are functioning correctly. Refer to Brake Caliper Guide Pins.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.