Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMREMOVAL AND INSTALLATIONHYDRAULIC CONTROL UNIT (HCU) - HYBRIDNOTES
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Hydraulic Control Unit (HCU) - Hybrid: Notes
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Notes
Material
| Item | Specification |
|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1-C (US); CPM-1-C (Canada) |
WSS-M6C62-A |
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Harness connector |
| 2 | - | Heat shield pin-type fastener (part of 2D000) |
| 3 | 2D000 | Heat shield |
| 4 | - | Brake fluid low pressure feed hose clamp (part of 2C058) |
| 5 | 2C058 | Brake fluid low pressure feed hose |
| 6 | - | Brake fluid low pressure return hose clamp (part of 2C059) |
| 7 | 2C059 | Brake fluid low pressure return hose |
| 8 | - | Brake tube-to-HCU fittings (10 mm) |
| 9 | - | Brake tube-to-HCU fittings (12 mm) |
| 10 | W711254 | HCU bracket-to-frame studs (3 required) |
| 11 | 2C555 | HCU |
| 12 | 2C549 | HCU bracket |
| 13 | 2C239 | Grommets (3 required) |
| 14 | W505260 | Heat shield bolt |
| 15 | - | Ground wire eyelet (2 required) |
| 16 | W705790 | Ground wire nut (2 required) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.