Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEWINDOWS AND GLASSDIAGNOSTIC TESTSGLASS, FRAMES AND MECHANISMSCOMPONENT TESTGRID WIRE TEST
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Grid Wire Test
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Grid Wire Test
- Using a bright lamp inside the vehicle, inspect the wire grid from the outside. A broken grid wire will appear as a brown spot.
- Run the engine at idle. Set the rear window defrost switch to ON. The indicator light should come on.
- Working inside the vehicle with a voltmeter, contact the broad, red-brown stripes of the back glass window positive lead to battery side and negative lead to ground side. The meter should read 10-13 volts.
- Contact a good ground point with the negative lead of the meter. The voltage reading should not change. A voltage reading of less than 10 volts indicates a loose ground connection.
- With the negative lead of the meter grounded, touch each grid line of the rear window defrost glass at its midpoint with the positive lead. A reading of approximately 6 volts indicates that the line is good. A reading of 0 volts indicates that the line is broken between the midpoint and the B+ side of the grid line. A reading of 12 volts indicates that the circuit is broken between the midpoint of the grid line and ground.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.